10. Use the screens to visually check the horizontal and vertical alignment between each tile.
If needed, use the vertical and horizontal screws to make adjustments.
11. Temporarily remove the screen from the last tile to allow another tile to be added to the row.
12. Repeat steps 5 to 11 for all remaining tiles that are to be used in the first row.
13. Assembly only a right leveling foot to the last tile in the row and secure it to the previous tile.
14. (Optional) Hand thread a horizontal adjustment screw into the mounting points between the
first two tiles. To allow for adjustments, do not completely tighten until the entire row is
complete.
It is recommended that horizontal adjustment screws be installed on additional rows when
assembling an array higher than three rows to ensure fine optimization of seams. For arrays
that are three rows or less it is not necessary to install the horizontal adjustment screws.
15. Repeat step 14 for every tile added to the first row.
16. Once the first row is assembled, place a straight edge onto the interface pads (circled in the
image below), along the top of each tile to ensure the row is flat. If needed, adjust the vertical
screws (if mounted to leveling feet) and the horizontal adjustment screws.
Poor alignment of the first row limits the size of the array that can be built.
17. Lock the latch (B) from one display unit onto the adjacent display unit. Repeat for every tile in
the row.
18. If the array is mounted to leveling feet, use the assembly tool to completely tighten all vertical
screws.
19. Use a 5mm hex key to completely tighten all horizontal adjustment screws.
20. If the array is mounted to the leveling feet, insert shims into either the front or the back (or
both) of each leveling foot to tilt the array or provide additional security. If necessary, fasten
the leveling feet to the base structure.
21. (Optional) Fasten the grilles to the leveling feet.
22. Add the second row of tiles.
Installation and Setup
Christie MicroTiles Installation and Setup Guide
21
020-100329-15 Rev. 1 (05-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.
