Christie M35GPS-AT, Operating Instructions Manual

Page: 15 / 94

3
CHRISTIE INCORPORATED
P35GPS Projector 3-1
June, 1998
3 . P R O J E C T O R I N S T A L L A T I O N A N D
A S S E M B L Y
3.1. U
N P AC K I N G T H E
P
R O J E C T O R
Before opening box(es), carefully inspect outside of carton(s). If carton
has been damaged, notify shipper immediately; do not open carton
unless instructed to do so.
The
CHRISTIE
P35GPS projector may be shipped in more than one container. Each
P35GPS projector normally comes complete with the following items:
•
dual aperture plate (shipped in place)
•
framing lamp (installed)
•
soundhead flywheel (not installed)
•
soundhead assembly (factory-aligned)
•
dual-lens turret
•
drive motor assembly
•
instruction manual.
The console and projector are shipped in a single carton, with special pockets containing
smaller items. The lens turret and soundhead flywheel are shipped separately.
To unpack:
1. Open carton(s).
2. Remove all protective material from framing lamp, soundhead assembly, and lens holder.
3. Remove protective material around side panel.
3.2. I
N S T AL L AT I O N
To install the projector, refer to Figure 3-1 . The required materials and tools for installing
and assembling the P35GPS projector are outlined in the Table in Figure 3-2.
1. Loosen but do not remove nut on projector mounting stud (item 4 in Figure 3-1 ). Verify
that lock washer (item 5 in Figure 3-1 ) and flat washer (item 6 in Figure 3-1 ) are correctly
positioned on mounting stud. Flat washer should be next to lock washer, followed by nut.