LW650 Lamp/Filter Replacement Instruction Sheet
3 of 3
020-000185-01 Rev. 1 (03-2009)
REPLACING THE FILTER CARTRIDGE
Always power down and disconnect/disengage all power sources to the
projector before servicing or cleaning.
Allow the projector to cool for at least 45 minutes before the lamp cover is
opened. The inside of the projector can become very hot and may cause injury.
NOTE:
To maintain normal internal ventilation replace the filter unit periodically.
1. Use a vacuum cleaner to remove dust on and
around the filter cover (Figure 3-Top-Left).
2. Lift and pull the bottom clips to remove the filter
cover (Figure 3-Top-Right).
3. Pinch and pull the filter clips to remove the filter
unit (Figure 3-Bottom-Left).
4. Use a vacuum cleaner to remove dust on and
around the intake vents of the projector (Figure 3-
Bottom-Right).
5. Install the new filter unit into the place.
6. Install the filter cover.
NOTICES: 1)
Make sure the filter cartridge is
correctly inserted into the projector otherwise, the
projector cannot be turned on.
2)
Do not block the air
vents. Doing so may result in malfunction of the projector.
3)
When using the projector under dusty or
smoky conditions, dust may accumulate on a lens, liquid crystal panels, or optical elements inside the
projector. Such conditions may degrade the quality of the projected image. When the symptoms above
are noticed, contact your authorized dealer or service station for proper cleaning.
RESETTING THE FILTER COUNTER
1. Switch the power button to ON.
2. Press the MENU button (on the control panel or the remote
control) to access the ADVANCED MENU. Use the
▲
/
▼
cursor buttons on the EASY MENU to select the
“ADVANCED MENU”, then press the
►
cursor button
(Figure 4).
3. Select the “FILTER TIME” using the
▲
/
▼
cursor buttons in
the right column, then press the
►
cursor button.
4. Use the
►
cursor button according to the dialog, Select “OK”
to reset the FILTER TIME value.
NOTES: 1)
The FILTER TIME value shown on the EASY menu is
the use time since the last time the FILTER TIME was reset. Refer
to the value for proper maintenance.
2)
Do not reset the FILTER
TIME without replacing a filter.
Filter cover clips
Filter unit clips
Figure 3 Filter Replacement
Figure 4 Filter Time Reset