2 of 3
LW650 Lamp/Filter Replacement Instruction Sheet
020-000185-01 Rev. 1 (03-2009)
1. Loosen the lamp cover screw (Figure 1-Top). Slide the cover to
remove it from the projector.
2. Loosen the 3 screws (Figure 1-Bottom) that attach the lamp unit
to the projector.
3. Use the handles to remove the lamp unit from the projector
(Figure 1-Bottom).
4. Set the new lamp unit into place and tighten the 3 screws that
attach it to the projector.
5. Slide the lamp cover back into place, and tighten the lamp cover
screw.
RESETTING THE LAMP TIME VALUE
1. Switch the power button to ON.
2. Press the MENU button (on the control panel or the
remote control) to access the ADVANCED MENU. Use
the
▲
/
▼
cursor buttons on the EASY MENU to select
the “ADVANCED MENU”, then press the
►
cursor
button.
3. Select “OPTION” using the
▲
/
▼
cursor buttons in the
left column, then press the
►
cursor button.
4. Select the “LAMP TIME” using the
▲
/
▼
cursor buttons
in the right column, then press the
►
cursor button.
5. Use the
►
cursor button according to the dialog, Select
“OK” to reset the LAMP TIME value.
NOTES: 1)
The LAMP TIME value shown on the OPTION
menu is the use time since the last time the LAMP TIME was
reset. Refer to the value for proper maintenance.
2)
Do not
reset the LAMP TIME without replacing a lamp.
Figure 1 Lamp Replacement
Figure 2 Lamp Time Reset
