Christie FHD551-W, User Manual

Page: 22 / 56

14 LCD Panel FHD551-W User Manual
020-100996-01 Rev. 2 (12-2012)
Installation
Install the Remote Control Batteries
1. Remove the battery cover, by lifting the tab of the battery cover.
2. Insert two AAA batteries into the remote control.
Correctly align the polarity of each battery with the polarity markings
inside the remote control.
3. Close the battery cover.
Disconnect Power from the LCD Panel
1. If the LCD panel is on, press Power OFF on the remote control.
2. Unplug the power cable.
3. Remove 4 screws (M6x30mm) from the exterior I/O cover.
4. Remove the external I/O cover
5. Remove the internal I/O cover.
6. Press the power switch to the O position.
7. Unplug the power cable and remove the cable from the interior I/O cover.
8. Hold the interior I/O cover against the LCD panel.
9. Place the exterior I/O cover over the interior I/O cover and secure in position using 4 screws.
To install the batteries, follow the instructions provided in the remote control battery
compartment. Incorrect polarities may cause operator injury, battery damage, and
contamination of the remote controller.
Use approved AAA batteries and do not mix different battery types or strengths.
The remote control is not waterproof.
i
To lock or unlock the remote, press
Enter
,
Enter
,
Exit
,
Exit
,
Enter
,
Exit
.
• Hold the power connector when removing the power cable. Removing the power cable by
the cord can damage the wires inside the cable and cause fire or electric shock.
• To avoid risk of electric shock, do not touch the power cable with wet hands.
Do not disconnect the AC power cord when Winter Mode is set to Enable.
See
Advanced Settings
on page 26.