Lamp safety precautions
Read all safety and warning guidelines before installing the projector lamp.
Warning! If not avoided, the following could result in death or serious injury.
•
This procedure must be performed by Christie qualified technicians.
•
EXPLOSION HAZARD! Always wear manufacturer approved protective safety clothing (gloves,
jacket, face shield) whenever the lamp door is open or when handling the lamp. Any local or
federal specifications take precedence over Christie's protective clothing recommendations.
•
Do not open the lamp door while the lamp is on.
•
EXPLOSION HAZARD! Allow sufficient time for the lamp to cool down before powering down the
product, disconnecting it from AC, and opening the lamp door.
•
EXPLOSION HAZARD! Do not stress the glass of a lamp or bare bulb in any way.
•
EXPLOSION HAZARD! Lamps and bare bulbs, even when packaged, may explode if dropped or
mishandled.
•
EXPLOSION HAZARD! Handle a lamp by the cathode and anode end shafts only. Do not handle
the lamp by the glass.
•
EXPLOSION HAZARD! Do not over-tighten the lamp.
•
Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
•
FIRE HAZARD! Keep hands, clothes, and all combustible material away from the concentrated
light beam of the projector.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Improper installation of the lamp can damage the projector.
•
Incorrect lamp power supply and igniter connections can damage the product.
AC power precautions
Read all safety and warning guidelines before connecting to AC power.
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! Only use the AC power cord provided with the product or recommended by
Christie.
•
FIRE AND SHOCK HAZARD! Do not attempt operation unless the power cord, power socket, and
power plug meet the appropriate local rating standards.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
•
SHOCK HAZARD! The optional UPS power cord must be inserted into an outlet with grounding.
•
SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
•
Install the product near an easily accessible AC receptacle.
Caution! If not avoided, the following could result in minor or moderate injury.
•
FIRE HAZARD! Do not use a power cord, harness, or cable that appears damaged.
•
FIRE OR SHOCK HAZARD! Do not overload power outlets and extension cords.
•
SHOCK HAZARD! Power supply uses double pole/neutral fusing.
Introduction
CP2420-Xe and CP4420-Xe Installation and Setup Guide
7
020-103555-01 Rev. 1 (03-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
