Lifting and positioning the projector
Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
•
Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
This product must be installed in a landscape orientation, with all four feet supported on a level
surface. Do not install or operate the projector in an inverted position. If your site has any installation
requirements other than a typical theater projection booth, contact Christie for assistance.
Before lifting and positioning the projector, refer to the light intensity hazard distance clearance
requirements (on page 7).
1. Position each person at the corners of the projector.
2. Place both hands under the corner, grasping the projector frame.
Do not lift the projector using any feature on the projector skin, such as the skin louvers or
lens opening.
3. Lift up the projector and move it to the location where it will be used.
4. Position the projector so it is centered and parallel with the theater screen. If space is limited,
aim the projector slightly off-center and use lens offset to center the image on the screen.
Connecting to power
The projector must be connected to power using a hard-wired connection.
The projector light source requires a permanent AC connection to operate. An uninterruptible power
supply (UPS) to provide backup power for the projector electronics only is also available. When
connecting the projector to AC power, follow all electrical codes for your location.
Warning! If not avoided, the following could result in death or serious injury.
•
Always connect the ground or earth first to reduce shock hazard.
•
FIRE HAZARD! Do not use a power cord, harness, or cable that appears damaged.
•
FIRE AND SHOCK HAZARD! Do not attempt operation unless the power cord, power socket, and
power plug meet the appropriate local rating standards.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
•
SHOCK HAZARD! A dedicated, protected ground or earth wire must be installed on the product
by Christie qualified technicians or electricians before it can be connected to power.
•
A certified electrician must be present during installation to ensure the installation meets the
local electrical code.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Use an appropriately sized strain relief connector with the knockout plate provided, to ensure
adequate environmental sealing and to prevent the AC supply cable from accidentally being torn
out or rubbing against the knockout plate.
Installing and setting up
CP2320-RGB Installation and Setup Guide
17
020-102773-02 Rev. 1 (05-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
Summary of Contents for CP2320-RGB
Page 1: ...Installation and Setup Guide 020 102773 02 CP2320 RGB...
Page 47: ......
