Christie BC-RAD 14XA Select, User Manual

Page: 11 / 17

9
3.1.2 – Unit Select Menu
The display units can be changed at any time using the Unit Select menu.
To enter the menu:
1. Press and hold both buttons on the Display Module until the Display flashes a pattern. The
Display will read “u- F” or “u- n” as shown in Figures 3.1.2-1 and 3.1.2-2 below.
Figure 3.1.2-1: Units – lbf.ft Figure 3.1.2-2: Units - Nm
2.
The units can be changed by pressing the Up or Down button to toggle between “F” (lbf.ft) and
“n” (Nm) units as desired.
To exit the Unit Select menu:
1. Press and hold both buttons on the Module until the Display flashes, then release the buttons.
2. The LED Display will light a small LED dot in the bottom left corner of the display when Nm
units are used (Figure 3.1.2-3), and will not light the dot when lbf.ft units are used (Figure 3.1.2-
4).
Figure 3.1.2-3: Nm Display Figure 3.1.2-4: lbf.ft Display
3.2 – Lock Mode
The BC-RAD Select Tool System has a built-in Lock function to prevent the user from changing pre-set
torque values or changing torque units. The set torque value will remain saved on the LED Display even
if the BC-RAD Select Battery is removed.
The BC-RAD Select requires a combination code to enter or exit Lock Mode. Contact W. Christie
(Industrial) LTD. See Section 7.0 for contact information.
When the BC-RAD Select Tool System is in Lock Mode, the torque value cannot be changed using the
Up or Down buttons. The BC-RAD Select must be first unlocked, the torque setting changed to the
desired value, then locked again to prevent the torque setting from being changed.
When the BC-RAD Select is put into Lock Mode, the LED Display will scroll the word “Lock” until the
buttons are released. In Lock Mode, the LED Display will light 2 small dots in the bottom left-hand side
of the display. When the BC-RAD Select is unlocked, the LED Display will scroll the word “unlock”
until the buttons are released.
4.0 – CALIBRATION
Calibration should only be carried out by W. Christie (Industrial) LTD.