- 5 -
Installing the adapter plate
Invert your flat panel and lay it gently on a soft and flat surface so
no damage will occur. Align the adapter plate with the four (4)
outer mounting points on the back of the flat panel, and then
secure it by using the four (4) M6 X 12 phillips head screws and
flat washers (supplied).
See figure 1.
WARNING!
INVERT THE FLAT PANEL AND PLACE IT ON A SOFT, FLAT SUFRACE TO PREVENT DAMAGE TO THE FLAT PANEL. USE A BLANKET, FOAM, ETC.
FAILURE TO DO SO WILL RESULT IN DAMAGING THE FLAT PANEL. DO NOT LAY THE PLASMA ON THE FLOOR WITHOUT ANY PROTECTION TO
THE GLASS. THE FLAT PANEL IS HEAVY AND FRAGILE. AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR
INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE
FLAT PANEL.
WARNING
: Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could
result in serious personal injury and possible damage to the flat panel.
M6 x 12 Phillip
screws
Blanket, foam etc.
Flat surface
Adapter plate
Flat washers
Inverted flat panel
Summary of Contents for 38-804785-01
Page 11: ... 11 ...
