Chore-Time KONAVI, Installation And Operator'S Manual

Page: 34 / 64

Anti-Roost Assembly KONAVI® Feeding System
34
MF2464C
9.At the control unit, after clamping the cable to the spring, cut the cable about 8" to 10" [200 to 250 mm]
longer than necessary. Feed the end of the cable through the center of the spring, around the first insulator on
the control unit, and clamp the cable using the cable clamp supplied with the control unit. (See Figure 46).
Install the wire form on the control unit insulators. Be sure the guard snaps into the retainers molded into the
insulators. (See Figure 46).
10.Install the Poultry Trainer or Line Charger, as shown in Figure 47. The Poultry Trainer is used to power all
Anti-Roost lines in a house.
•The Line Charger is used to power individual Anti-Roost lines in a house. (See Figure 47).
•Route the charger wire from the Poultry Trainer or Line Charger to the Anti-Roost system.
•Secure the Charger Wire to the Anti-Roost cable, using a cable clamp.
11.The anti-roost system must be on a separate electrical circuit, allowing the system to be disconnected
by a switch near the door.
Remember, the anti-roost system should be grounded through the poultry trainer.
Figure 46.Anti-Roost Installation at the Control Unit
Wire Form
Insulator
Clamp with Anti-Roost
Bracket and Insulator
Clamp
Spring Should be stretched
3/4" to 1" [19mm to 25mm]
Figure 47.Poultry Trainer and Line Charger
Insulated
Secure
Insulated
Anti-Roost
Anti-Roost