Chore-Time FLEX-IR ST73000, Installation And Operating Instructions Manual, Page: 10 / 12

11
8. Accessing Setup Menu
Note: Setup is not required for standard operation.
To access menu mode:
1. Turn power off to FLEX-IR™.
2. Rotate top knob to zero.
3. Turn power on and rotate top knob to RED ZONE within two seconds of power on.
4. Both Indicator lights will flash three times to indicate menu mode is activated.
To adjust FLEX-IR™ operating parameters:
1. Rotate bottom knob to feature to be changed.
2. Rotate top knob to desired mode.
3. Feature is changed and locked in when number of blips on top indicator light changes.
TOP
KNOB
0
ALARM RELAY IS ALARM SIGNAL OR RUN
SIGNAL
0 = ALARM SIGNAL DEFAULT 1 BLIP
RED ZONE = RUN SIGNAL 2 BLIPS
30
DELAY START AFTER POWERUP CONFIGURE
0 = 0 SECOND DELAY START
1 BLIP
30 = 3 SECOND DELAY START
DEFAULT 2 BLIPS
60 = 6 SECOND DELAY START
3 BLIPS
90 = 9 SECOND DELAY START
4 BLIPS
120 = 12 SECOND DELAY START
5 BLIPS
150 = 15 SECOND DELAY START
6 BLIPS
RED ZONE = DELAY START IS WHATEVER KNOB IS SET
AT
7 BLIPS
60
DELAY START KNOB MINUTES OR SECONDS
0 = MINUTES
DEFAULT 1 BLIP
RED ZONES = SECONDS
2 BLIPS
90
REMAIN IN MAX TIMED OUT AFTER CYCLING POWER
0 = YES
1 BLIP
RED ZONE = NO
DEFAULT 2 BLIPS
120
BLANK
150
RETURN TO FACTORY SETTINGS YES/NO
0 = YES
2 BLIPS (NOTE: Must exit menu through next step and not cycle
power to lock in factory reset)
RED ZONE = NO
1 BLIP
RED
ZONE
EXIT MENU YES/NO
0 = YES
RED ZONE = NO
NOTE: Cycling power will also exit the setup menu.
BOTTOM
KNOB