Chore-Time 108 FLEX-AUGER, Installation And Operator'S Manual, Page: 10 / 20

Installation Bin Fill Cap Kit
10
MA1038D
Model 108 Single and Twin Intermediate Fill Cap Kit
1.Place the Sponge Tubing (Item 12) over the lip of the bin fill collar.
2.Install the short Tube Anchor Weldment (Item 8) on the outside of the Bin Cover Weldment (Item 11).
3.Caulk or silicone the Anchor Tube Weldments against the Cover Weldment.
4.Install the Slide Shut-offs on the Tube Anchor Weldments.
See Figure 7 (on page 11)
5.Install the Tube Anchor Weldment (Item 5) on the inside of the Cover Weldment (Item 11) .
6.Set the Cover Weldment over the bin opening in line with the supply bin.
7.Install the Auger Tubes from the boot on the supply bin to the Cover Weldment.
8.Use a Tube Clamp
(Item 9) to secure the Auger Tube(s) to the Tube Anchor Weldment(s).
9.Drill holes and fasten the Cover Weldment (Item 11) to the bin fill collar with the 5/16" x 1-1/2" bolts and
locknuts supplied.
(40526) Twin Fill Kit (40527) Single Fill Kit
40526 40527
Item Description Part No.
1 Danger Electrical Decal 2527-25 2527-25
2 Danger Moving Auger Decal 2527-9 2527-9
3 Lid Assembly 7689 7689
4 Shut-off Half 40530 40530
5 Twin Tube Fill Weldment 40522 --
Single Tube Fill Weldment -- 40523
6 Over Center Clamp 2536 2536
7 Double Insulated Bushing 6343 6343
8 Tube Anchor Weldment 4-37332 4-37332
40526 40527
Item Description Part No.
9 Tube Clamp 14373 14373
10 Tube Insert 34337 34337
11 Twin Cover Weldment 40533 --
Single Cover Weldment -- 40534
12 Sponge Tubing 5928 5928
-- Cord 3085-8 3085-8
-- Red Indicator Ball 24393-1 24393-1
-- Green Indicator Ball 24393-2 24393-2
Figure 6.Single and Twin Intermediate Fill Cap Assembly