Chore-Time 108 FLEX-AUGER, Installation And Operator'S Manual, Page: 11 / 20

Bin Fill Cap Kit Installation
11
MA1038D
10.Assemble the Shut-Off using (6) 1/4-20 bolts and nuts provided into (3) center holes on each flanged side.
This leaves the end holes for activator cord attachment.
11. Set the cover weldment over the bin opening in line with the other bins. The outlet hole in the fill tube
(inside the cover weldment) should be on the inlet side of system. This allows feed to fall more centered
in the bin.
12. Determine proper pull cord arrangement for the hopper bin set up. Insert cord thru bushings on both ends
(single) or sides (twin) and attach to opposite ends of the shut-off slide. Insert cords thru holes provided on
ends of shut-off and tie a secure knot in cord ends.
MA1019-3 9/97
1
2
3
4
5
6
4
Item Description Part No.
1 Fill Tube Weldment (Twin)
Fill Tube Weldment (Single) 40522
40523
2 Shut-Off Half 40530
3 1/4-20 x 1/2 Bolt 1487
4 Possible Cord Position
5 Bolt Locations
6 1/4-20 Lock Nut 1269
Figure 7.Shuttoff Assembly
MA1019-4 9/97
1
2
1
3
4
Item Description Part No.
1 Cord 3085-8
2 Intermediate Fill Cap (Twin) --
3 Shut-Off 40530
4 Intermediate Fill Cap (Single) --
Figure 8.Cord arrangement