4
outputs on the CPM 2650
CPM 2650
You need to connect the outputs on the back of your integrated amplifier to your
loudspeakers. You can use any speakers that match the output power of your
amplifier. Note that the lower the impedance of your speakers the higher the
output power.
connecting to your loudspeakers
1.
The loudspeaker connections are via two heavy duty WBT gold plated binding
posts labelled O/P 1 and these should be connected to your speakers.
2.
On your remote control press HIFI and then OP 1 to output the signal to your
loudspeakers.
Note: The WBT rhodium plated 4mm speaker binding posts will accept 4mm banana
plugs (WBT-0645 or WBT-0644) or 6mm spades (WBT-0680). Making connections
using bare wire is not recommended.
using your integrated amplifier as a pre-amplifier
You can use your integrated amplifier as a pre-amplifier to provide a signal for
another power amplifier.
1.
Use RCA style connectors to connect Right O/P 2 to the Right IN on your
power amplifier, and connect Left O/P 2 to the Left IN on your power
amplifier.
2.
On your remote control press HIFI and then OP 2 to output the signal to
the power amplifier.
