13
Step 5- Choose the output channel(s) to be
used for stimulation.
Press the CHA button on the front of the unit to turn on or
off the corresponding output channels (Both A&B are ON by
default).
IMPORTANT: Before stimulation, you must plug the wire
into the output port and place the pads on the skin.
You can use one channel at a time or both channels
simultaneously as long as the output channel is turned
on, wires are connected and pads are attached to skin.
Step 6- Select one of the seven stimulation
modes.
Press the MODE button to switch between stimulation
modes: Mode1, Mode 2, Mode 3, Mode 4, Mode 5, Mode 6
and Mode 7. LCD Screen shows the current mode.
Step 7- Set the stimulation time.
Press TIME to set the duration. The time can be set from 5
minutes to 20 minutes.
Step 8- Adjust the stimulation intensity.
Pressing on the
&
buttons will Decrease & Increase the
intensity level of stimulation.
NOTE: With the increase of intensity, you may experience
sensations like tingling, vibration, pain, etc. Therefore,
gradually increase the intensity. When the most
comfortable level is reached, stop increasing.
Step 9- Press the ON/OFF button once to turn
the unit off.
After the device is turned off, disconnect the wires and
electrode pads. If you plan not to use the device for a long
time, please remove the battery from the device.
Summary of Contents for MDTS100
Page 22: ......
