ChoiceMMed MDTS100, Instruction Manual

Page: 14 / 22

12
dESCRiPTiON OF OPERATiON diAGRAM
Step 1- insert the 2 AAA batteries into the
device.
Make sure the unit is OFF. Slide the compartment cover on
the back of device downward until the cover pops off. Insert
2 AAA batteries according to the diagram inside the battery
compartment. Close the cover.
Step 2- Connect the electrode pads to the
wires and then connect the wires to the device.
Plug the connecting wires into the electrode pads. Then
connect the wires to the device’s output channels. Two output
channels can be used simultaneously or one at a time. Select
channel by pressing CHA Button.
NOTE: If you connect wires to both A and B outputs,
you must turn on both A and B channels and have pads
connected. These pads MUST be placed on the body for
stimulation to occur.
Step 3- Place the electrode pads on the part of
the body that needs stimulation.
In order to achieve the best relief results, place the electrode
pads around or on the top of your painful areas. If possible,
always use all the 4 electrode pads at the same time. (If all
4 pads are being used, both outputs must be turned on).
Electrode pads should be placed between 0.5″ to 1.5″ apart
from each other based on the relief area. Make sure the pads
stick firmly on the skin. Do not move or remove the pads
when the device is on.
Clean your skin before each use. Make sure your skin is
clean, dry and free from lotion before placing the electrode
pads on your skin.
Step 4- Press the ON/OFF button once to turn
the unit on.
The LCD display will show 7 stimulation modes.