S
ECTION
III:
S
ETTING
S
ERVICE
O
PTIONS
page,
Section III
913-623 @Rev A
Setting Service Options
10
Group
Settings
Execute at [N] minutes
remaining time:
Send Shutdown Messages to all IP Addresses in the
Group if the UPS is running on battery power and the
amount of remaining time is estimated to be [N]
minutes.
Execute after [N]:
Where N is the number of minutes on battery to wait
Protocol:
Select the protocol of the shutdown targets. If the
shutdown target is running RCCMD listener module,
select RCCMD. If the target is running MopUPS
network shutdown agent (NSA), select
MopNSA
.
IP Address From:
The IP address of the first computer in a range to
receive
Remote Shutdown
signals.
Formatted as
XXX.XXX.XXX.XXX.
IP Address To:
The fourth octet of the last computer in the range to
receive Remote Shutdown messages. Must be a
number greater than the fourth octet of the
corresponding
IP Address From
, and must be less than
255.
Port for Shutdown Sequence:
The TCP/IP port each of the computers in this range is
listening on for Remote Shutdown messages.
Port for Restart Sequence
(RCCMD Only):
The TCP/IP port each of the computers in this range
are listening on for RCCMD restart messages
Password
(MopNSA only):
The password entered on the target computer for
access to the MopUPS service.
ManageUPS must present the correct password to the
shutdown target in order to be authenticated with rights
to trigger shutdown of the target host operating system.
Summary of Contents for ManageUPS
