8
SEAT UNIT
FOLDING THE STROLLER
fig. 16
fig. 17
fig. 18
fig. 19
fig. 20
fig. 21
Place the seat with locking parts above the universal fixation points of the frame, then push
it down until it securely clicks
(fig.16)
.
The seat can be mounted in two directions, allowing face to face and forward facing mode.
IMPORTANT!
When you install the seat in forward facing mode, the two plastic hooks
below the seat must be in front of the two horizontal tubes of the frame, as shown in
fig.17
.
Otherwise, you will not be able to fold the stroller with the seat on. Always check the
position of the hooks after installing the seat!
When the seat is in rear facing mode, the support belt on the back of the seat must be
fastened to the frame , as shown in
fig.18
.
To remove the seat, push the two release buttons on both sides of the seat in forward
direction until it is released (as shown in
fig.19
) and pull the seat up.
IMPORTANT!
When the seat is in rear facing mode, you must unfasten the supporting belt
before removing the seat!
IMPORTANT!
Make sure the seat is correctly installed before each use.
ATTENTION!
Make sure that the child is at a safe distance from the stroller during folding
and unfolding.
Remove the seat and apply the brakes. Adjust the handle in the lowest position. Pull up the
folding mechanism, which is on the left side of the handle
(fig.20)
and press down until the
frame is folded. The stroller will lock automatically and you will hear a click
(fig.21)
. Make sure
the stroller is locked.
ATTENTION!
You can fold the stroller with the seat on, only if the following is done:
1. The seat is in forward facing mode
2. The plastic hooks
(fig.17)
are in front of the frame tubes!
3. The backrest is in most upright position.
Only in these conditions the stroller may be fully folded with the seat on.
