www.chinowing.com
68
After connecting the V40 to the computer, check that its network settings
(TCP/IPV4 properties) and set it to "192.168.168.xxx" (xxx is the address value in
the middle of 0 to 255, where 192.168.168.1 and 2, 19, 13 addresses are reserved
and cannot be used )
Let's take VLC software as an example,
the first step is to open the VLC software, the second step is to open "Network
Streaming" in "Media" as shown below
The third step: Enter the pull stream address, note: the V40 HDMI module is
factory set with a default IP address of "192.168.168.13"
Enter the following address:
rtsp://192.168.168.13:554/stream0
