www.childcare-prod.com.au
www.childcare-prod.com.au
3
6
Folding the Stroller
• Apply rear brake and disengage swivel lock.
• Return seat to layback position.
• Close the hood and remove bootcover.
• Lift the secondary lock circled whilst
simultaneously pulling up the two release catches
located either side of the handle which will release
the elbow joints for smooth folding.
• Push the handle gently downwards towards the
floor, folding the handle underneath the back rest.
• Close the folding lock.
• For a compact fold, ensure the handle bar sits
under the backrest. The second position of the
upfold lock can then be used.
Warning:
The brake must be engaged when folding the
stroller.
Assembling Instructions
Front Wheel Assembly
• Loosen the wheel bolt using the quick release
handle. There is no need to unscrew
completely.
• When there is a big enough gap on each side,
slide the bolt onto the hooks located on the
front of the chassis
• With the bolts you will find two ‘L’ shaped
washers which must hook into the small hole
located above the hook where the bolt sits.
• Tighten the bolt with both hands, again using
the quick release handle in one hand and hold
the bolt with the other hand. When you can
feel the bolt nearly tight, flip the quick release
handle back to lock into position. Gently pull
on the wheel to ensure that it is fitted
correctly and securely.
Brakes
•
Push down the rear lever to park.
•
Check to make sure the brake is on by trying to
push the stroller.
•
Lift up to release.
Warning:
Always apply brake when parking the
stroller.
To Open the Stroller
•
Lift the folding lock.
•
Lift the handle until it locks into position.
•
Check that the latches on both sides are
locked before continuing assembly.
Bootcover
• Place bootcover over bumper bar and connect
the upper straps around the handle tube above
the leg handle mouldings, and over the lower
end of the bootcover under the seat where
velcro straps connect the front legs of each
side.
Warning:
Always remove the bootcover before
folding the stroller.
Rear Wheel Assembly
• Place the axles into the holes on
the rear of chassis until they click
into position.
• Ensure that they are securely
fitted by pulling firmly on the
wheel.
Warning:
Make sure these washers are
placed in exactly the same position on both
sides, failing to do this will cause your stroller
to veer to one side.
