4
5
Figure 3
STEP 3
O
AB20047_G7
N
B
H
E
STEP 4
Figure 4
L
AB20047_G8
B
E
E
O
H
Figure 5
STEP 5
Assemble Front Stationary Side to crib.
Insert Joint Connector Nuts B into Front Stationary
Side M .
Insert Allen Head Bolts E into Finished End Panels
O and H . Rotate Joint Connectors Nuts B to
align threads with bolts and snug with Allen wrench.
Tighten all bolts securely including Bolts E at
stretcher which were not fully tightened during
step 4
See figure 5
Assemble End Panels to Back Stationary Side.
Insert Joint Connector Nuts B into Back Stationary
Side N . Insert Allen Head Bolts E into Finished
End Panel Footboard H . Rotate Joint Connector
Nuts B to align threads with bolts and snug with
Allen wrench .
Repeat procedure with finished End Panel
Headboard O .
Tighten all bolts securely.
See figure 3.
Assemble Stretcher to crib.
Insert Joint Connector Nuts B into Stretcher L .
Align and insert tenons on end of stretcher into
slotted holes in Finished End panels O and H .
Insert Allen Head Bolts E into Finished End Panels
O and H . Rotate Joint Connectors Nuts to align
threads with bolts and loosely tighten with Allen
wrench.
Do Not tighten bolts securely until end of step 5.
See figure 4.
AB20047_G9
E
E
M
B
B
O
H
AB20047_G10
3
2
1
D
R
Figure 6
STEP 6
Add Mattress Spring to crib.
There are 3 positions for the Spring R shown as 1
2 , 3 . Refer to warning section to determine
appropriate height for the intended child. The
position must be the same as for all the brackets
attached to the crib.
Note: Pouches containing warnings and instructions
face up on top surface of Spring.
Position tabs on Spring at approximately a 45
degree angle. The Spring R is lowered into the
crib. Take care not to scratch the wood with the
metal spring. Align the Spring Brackets with the
holes in the crib at the
desired height. Insert Bolt D into hole in spring
brackets from inside of crib then through correct
height hole in the crib.
Tighten all bolts securely with Allen wrenches.
To Adjust height of Spring R remove bolts D .
Then relocate Spring R to new height adjustment
level and install Bolts D as described in previous
paragraph.
See figure 6.
