XBM1U/XBM1UP
Installation Instructions
8
Column Add-On Installation (Optional)
NOTE:
Column add-ons (EE) are only required for extra large
displays or if a higher mounting height is desired than
can be achieved with the standard columns (J). If add-
ons are not going to be installed, proceed to Rail
Installation Section.
1.
Insert one column add-on (EE) to each column (J) making
sure holes are lined up on each side. (See Figure 4)
2.
Use 5/32” hex key (CC) and six 1/4-20 x 1/2” flat head cap
screws (FF) to secure each column add-on (V) to each
column (J). (See Figure 4)
Figure 4
Rail Installation
1.
Using display dimensions, determine where the center of
the display will be on the cart.
IMPORTANT ! :
If installing column add-on accessories
(not included), install them prior to installing rail (R) to
columns (J).
2.
Place clamp brackets (N) on columns in the position of
where the center of the display will be on the cart with the
diamond on the brackets being placed at the exact center
location. (See Figure 5)
Figure 5
3.
Use 5/16-18 x 4 1/2” button head cap screw (V), two 5/16”
washers (X) and 5/16-18” lock nut (Z) to secure each clamp
bracket (N) to column. (See Figure 5)
4.
Use four 5/16-18 x 3/4” button head flange screws (W) to
secure each attached clamp bracket (N) to each quick
connect base (Q). (See Figure 6)
Figure 6
NOTE:
If rails must be installed over cable management holes
on column, cables must be routed prior to installing
rails onto quick connect bases. See Cable
Management section for details.
5.
Install two 5/16-18 x 3/4” button head flange screws (W) into
the top holes on each quick connect base (Q). (See Figure
7)
6.
Hang single display rail (R) onto screws installed in previous
step to quick connect bases (Q). (See Figure 7)
Figure 7
(rear view)
(EE)
1
2
(FF) x 6
(J)
2
2
(rear view)
(V) x 2
(Z)
3
3
(CC) x 2
center of display
(N)
(N)
(Q)
(W) x 4
4
(N)
(rear view)
(W) x 2
6
6
5
(Q)
(R)
(rear view)
