WP2XS, WP2XUS
Installation Instructions
8
IMPORTANT ! :
See
Site Requirements
section before
proceeding with Steel Studs installation to ensure
installation site meets requirements! The drywall must
have a minimum thickness of 1/2"!
1.
Determine mounting location on wall. Use stud finder to
locate steel studs.
2.
Line up four holes on wall plate (E) with center of studs at
desired mounting location. (See Figure 4)
3.
Using wall plate as a template, mark four holes at the four
holes in wall plate. (See Figure 4)
4.
Drill four 1/2" holes at marked locations on wall. (See
Figure 4)
Figure 4
5.
Hold metal channel on Toggler® 1/4-20 (BB) Snap-Toggle
(not included) flat alongside plastic straps and slide channel
through hole. (See Figure 5)
Figure 5
6.
Holding plastic straps on anchor, pull anchor away from wall
until channel rests flush behind wall making sure anchor
channel is positioned vertically on stud. (See Figure 6)
7.
Slide plastic cap on anchor towards wall until flange of cap
is flush with wall. (See Figure 6)
Figure 6
8.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 7)
9.
Repeat Steps 6 through 8 for each mounting hole.
Figure 7
3
4
x 4
(E)
x 4
Drywall
Plastic Straps
5
anchor x 4
Plastic Cap
Drywall
Anchor Metal Channel
7
Steel Stud
6
(side view)
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
8
Steel Stud
(side view)
