Installation Instructions
WMA1S
9
Installing Mount Covers
1.
Raise lower cover (X) up to WMA1S. (See Figure 12)
Figure 12
2.
Lower top cover (W) onto WMA1S. (See Figure 13)
3.
Install two #10 x 1" Phillips pan head tapping screws (V)
through holes on sides of covers. (See Figure 13)
4.
Install two #8 x 1/2" Phillips pan head tapping screws (U)
into top of top cover (W). (See Figure 13)
Figure 13
PROJECTOR INSTALLATION
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight
attached to the wall mount accessory up to (and including)
the attached component(s) does not exceed:
•
Installed in steel stud: 50 lbs (22.7 kg)
•
Installed in 2" x 4" wood stud: 150 lbs (68.0 kg)
•
Installed in concrete/concrete block (with NO drywall
attached to wall): 150 lbs (68.0 kg)
Column (not included) Installation
1.
Line up mounting holes on column (not included) with
corresponding hole on WMA1S mounting plate. (See
Figure 14)
IMPORTANT ! :
The maximum length column that can
be attached to the WMA1S is 48 inches (121.9 cm).
2.
Install column (not included) following instructions included
with column.
3.
Install one 5/16-18 x 1/4" set screw (P) or one 5/16-18 x 1/4"
security set screw (Q) through hole in WMA1S mounting
plate and column. (See Figure 14)
Figure 14
(X)
1
2
(W)
3
(V) x 2
4
(U) x 2
3
(P) or (Q) x 1
1
Column
(not included)
(side view)
