TS525TU
Installation Instructions
6
Assembly And Installation
Install Wall Plate to Wall - Wood Studs
WARNING:
Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component. The wall to which the mount is being attached
may have a maximum drywall thickness of 5/8" (1.6cm).
1.
Determine mounting location. Use stud finder to locate 2" x
4" wood studs.
2.
Measure 9 5/16" above desired center line and draw a
horizontal line. (See Figure 1)
NOTE:
Hold mount up to wall at desired mounting location if
unsure about where the center line will be. The center
line of the mount will coincide with the center line of the
display. (See Figure 1)
IMPORTANT ! :
Use a level to make sure wall rail (N) is
level when mounted to the wall!
3.
Drill two 13/64" holes at center of wood studs along the line
drawn in the Step 2. (See Figure 1)
Figure 1
4.
Loosely attach wall rail (N) to wall using two 5/16- 2 1/2"
flange head lag screws (F). (See Figure 2)
5.
Place two installation spacers (H) over two 5/16 x 2 1/2"
flange head lag screws (F). (See Figure 2)
6.
Tighten two screws (F) to secure upper wall rail (N) to wall.
(See Figure 2)
Figure 2
7.
Slide main assembly (M) onto wall rail (N). (See Figure 3)
Figure 3
8.
Center main assembly (M) over two studs.
9.
Drill two 13/64" holes in center of wood studs at lower
mounting holes. (See Figure 4)
10. Loosely install two 5/16 x 2 1/2" flange head lag screws (F).
(See Figure 4)
11. Place two installation spacers (H) over two flange head lag
screws (F). (See Figure 4)
12. Tighten two screws to secure main assembly (M) to wall.
(See Figure 4)
3
center line
(M)
x 2
9 5/16
16"
(F) x 2
(H) x 2
(N)
4
6
7
(N)
(M)
