SPOM1
Installation Instructions
4
MOUNT ASSEMBLY
The only assembly required on the SPOM1 is attaching a
cable management clip to each side of the mount face
plate.
To attach the cable management clip:
1.
Pull mount face plate outward until access to rear of
face plate can be achieved.
2.
Install two cable management clips (140) into each
side of mount faceplate. (See Figure 2)
Figure 2: Install Cable Management Clips
MOUNT INSTALLATION
WARNING:
The installer is responsible for verifying that
the structure to which the mount is anchored will safely
support five times the combined load of the mount and all
attached components.
To install mount:
1.
Identify appropriate mounting location.
2.
Locate studs.
NOTE:
The SPOM1 is designed to be mounted on 16" on
center wood studs.
3.
Place mount assembly against wall, level mount, and
mark pilot hole locations (See Figure 3).
Figure 3: Locate, Mark and Drill Pilot Holes
WARNING:
Keep hands and fingers away from pinch
points as mount may move from retracted to extended
position when being positioned on wall.
4.
Drill four .200" pilot holes, at marked locations
(See Figure 3).
5.
Place mount assembly against wall and align
mounting holes in mount assembly with pilot holes
(See Figure 4).
6.
Secure mount to wall studs using four wood screws
(20), and four FW (30).
Figure 4: Install Mount
Face Plate
Cable Management Clip
.200" Pilot Hole
(Mark and Drill)
Mount Assembly
Wall Studs
(20)
(30)
