CHIEF SMART-LIFT SL236i, Installation Instructions Manual

Page: 9 / 20

Installation Instructions SL236i
9
Figure 9
13. Line up clips on four corners of ceiling panel with holes in
SL236SPi.
14. Re-install four clips on ceiling panel into rectangular holes
on SL236SPi. (See Figure 9)
15. Reattach guide wires (two places) to SL236SPi, using nuts
removed earlier in Step 1 of Installing in a Suspended
Ceiling section. (See Figure 9)
16. Install ceiling tile and grid by sliding it into the open end of
the ceiling tile retainer.
CAUTION:
Do NOT allow parts of ceiling tile or grid to
protrude from the ceiling panel. Ensure that all parts
assemble easily when installing ceiling tile into ceiling panel.
Any protruding parts may cause damage to the lift and/or
ceiling.
17. Re-install ceiling tile retainer to ceiling panel and secure
with four screws removed in Step 10. (See Figure 8)
18. Use the provided push button (B) to operate the SL236SPi
up and down, ensuring that all clearances are adequate
after the ceiling has been finished.
Installing in a Wood Framework (SL236FDi Only)
1. Use 1/4" x 1" (minimum) Grade 2 lag screws (not provided)
to secure SL236FDi to the joists or wood framework, using
the mounting tabs located on the sides of the SL236FDi
housing. (See Figure 10).
NOTE:
There are three mounting tabs on each side and two
mounting tabs on the front of the SL236FDi. There are
three mounting holes in the back of the SL236FDi. The
SL236FDi must be installed using the back mounting
holes AND the front two mounting tabs on both sides,
OR by using the back mounting holes AND the front
mounting tabs.
IMPORTANT ! :
Wood framework must be constructed of
nothing larger than 2x6 wood studs across the rear of the
SL236FDi. There are no size limitations for the wood framework
on the other three sides of the SL236FDi.
Figure 10
CAUTION:
The lift MUST be installed square and parallel.
Do NOT stress or bend the lift during installation.
2. Use the provided push button (B) to operate the SL236i up
and down, ensuring that all clearances are adequate.
Installing Projector on SL236i
NOTE:
The projector is secured from the top by an SLB
bracket (a Listed accessory which is not included).
1. Attach the SLB bracket to the projector using the hardware
and instructions included with the bracket.
Rectangular
hole
15
x 2
14
Guide
wire
Clip
Mounting
Tabs
Mounting
Tabs