SL220-SK2
Service Manual
6
11. Set motor assembly (A) into place.
12. Attach motor assembly (A) to motor bracket using two
1/4-20 x 3/8" flat head screws (B) and two screw bushings
(F). (See Figure 13)
Figure 13
13. Connect motor cable behind panel (next to motor
assembly). (See Figure 13)
14. Replace panel and secure in place with four 08-32 x 3/16"
Phillips head screws (C). (See Figure 13)
15. Replace four screws into lifting nut near control assembly.
(See Figure 14)
NOTE:
Ensure that longest screw is replaced in the proper
location. (See Figure 14)
Figure 14
16. Attach back wall to SL220 assembly using eight Phillips
head screws. (See Figure 15)
Figure 15
INSTALLING SL220 INTO CEILING
1.
Check that four corner latches on SL220 lift assembly are
extended and ready to latch to SL220 frame.
2.
Orient lift assembly so that the rear of the SL220 (with the
electrical opening) lines up with the outlet box attachment
plate on the SL220 frame. (See Figure 16)
3.
Lift SL220 lift assembly into place through the SL220 frame.
(See Figure 16) Ensure that there are four audible clicks---
each corner hook "clicking" into place onto the frame. (See
Figure 17)
Figure 16
4.
Lower onto SL220 frame, carefully lining up outlet box
attached to SL220 frame, with opening at rear of SL220.
(See Figure 17)
5.
Secure the SL220 to the SL220 frame using four 8-32 x 1"
Phillips head screws (previously removed), two in the front
and two in the back of the SL220. (See Figure 17)
12
(B) x 2
(F) x 2
14
(C) x 4
13
Panel
15
x 4
Control
assembly
16
x 8
Back wall
Rear of
SL220
3
Electrical
Opening
SL220 frame
Outlet box
attachment
plate
