Installation Instructions
PACCS1
5
ASSEMBLY AND INSTALLATION
NOTE:
The PACCS1 is designed to accommodate both
200mm x 200mm and 14" x 14" Q-latch mounting
systems. If a 200mm x 200mm pattern is required, use
the inner mounting holes on the shelf bracket (A) when
installing the uprights (D and E). (See Figure 2)
NOTE:
The 14" x 14" display mounting pattern is NOT identical
to a 400 x 400 VESA display mounting pattern.
IMPORTANT ! :
If installing the PACCS1 with the PACLR1
the top mounting flange on the PACCS1 must hang over the top
of the lower speaker rail on the PACLR1 when installed. (See
Figure 3)
Assemble PACCS1
1.
Install top two mounting buttons (F) to uprights (D and E)
using two 10-24 x 7/8" button head cap screws (R) and two
10-24 lock nuts (L). (See Figure 1)
Figure 1
2.
Assemble two lower mounting buttons (F) to uprights (D and
E) and shelf bracket (A) using two 10-24 x 7/8" button head
cap screws (R) and two 10-24 lock nuts (L).
3.
Complete attachment of uprights (D and E) to shelf bracket
(A) using two 10-24 x 1/2" button head cap screws (Q) and
two 10-24 lock nuts (L). (See Figure 2)
Figure 2
4.
Assemble adjustment bracket (B) to shelf bracket (A) using
four 1/4-20 x 5/8" button head cap screws (N) -- two on each
side of adjustment bracket. (See Figure 3)
Figure 3
5.
Lower shelf (C) to the assembly. (See Figure 4)
6.
Attach shelf (C) using two 1/4-20 x 5/8" round head carriage
bolts (P), two 1/4" flat washers (S) and two 1/4-20 nylon lock
nuts (M). (See Figure 4)
1
(R) x 2
(F) x 2
(L) x 2
(E)
(D)
(D)
(E)
(A)
(Q) x 2
(F) x 2
(L) x 2
(R) x 2
Attachment for
200mm x 200mm
3
2
4
(N) x 4
(B)
(A)
PACLR1
