Model: MWC Series
Installation Instructions
4
INSTALLATION
MOUNT INSTALLATION
Three installation options exist:
•
Dual Wood Stud (16" on-center; requires 5/16" x
2-1/2" long hex head lag screws)
•
Dual Steel Stud (requires Chief PAC-115 Steel
Stud / Drywall Anchor Kit; not included)
•
Drywall (1/2" minimum; requires Chief PAC-115
Steel Stud / Drywall Anchor Kit; not included)
The following instructions are for dual wood stud
installation. See instructions included with PAC-115 for
dual steel stud or drywall installation.
1.
Determine approximate mounting location, keeping in
mind the display size.
2.
Use a stud sensor to locate applicable wood studs.
Mark locations with a pencil.
3.
Level mount at desired height. Using mount as a
template, mark the location of four pilot holes. Ensure
marks are in the center of wood studs.
4.
Drill pilot holes using a 7/32" drill bit. Ensure pilot
holes are straight.
5.
Using 1/2" wrench, install four 5/16" x 2-1/2" hex head
lag screws (70) and four 5/16" washers (80) through
the mounting slots in the side plates into the pilot
holes (See Figure 2). Tighten all lag screws.
Figure 2: Mount Installation
CPU INSTALLATION
WARNING:
Exceeding the weight capacity can result
in serious personal injury or damage to equipment! It is
the installer’s responsibility to make sure the combined
weight of all components attached to the MWC Series
Wall Mount, including the CPU and display, does not
exceed 100 lbs (45 kg).
1.
Using key (60) remove and retain
upper
front plate
attach screws and washers (See Figure 3).
NOTE:
Lower
front plate attach screws may remain
installed.
Figure 3: Upper Front Plate Attach Screws
2.
Tilt front plate away from wall and then lift out of lower
front plate attach screws (See Figure 4). Place front
plate on protective surface.
Figure 4: Remove Front Plate
3.
Loosely thread strap (20) through side plates so that
buckle is in front (See Figure 5).
NOTE: Drywall not
shown for clarity.
Side Plates
(70) x 4
(80) x 4
Upper front plate
attach screws and
washers (2 places)
Front
Plate
1
2
Front Plate
Lower front
plate attach
screws
(2 places)
