Installation Instructions
MSPFB3
7
WARNING:
Keep hands and fingers away from all
pinch points when moving the mounted display from
the retracted to the extended position.
2.
Slowly rotate display to "fully right" position and
identify the area of contact between the display and
cabinet.
3.
Remove adhesive back from felt pad (C) and place
pad onto display at identified point of contact.
4.
Slowly rotate display to "fully left" position and identify
the area of contact between the display and cabinet.
5.
Remove adhesive back from felt pad (C) and place
pad onto display at identified point of contact.
ADJUSTMENTS
The mount is shipped with pre-set tension for swing arm
movement. After extended use mount tension may need
to be adjusted.
There are a total of 12 tension adjustment points on the
mount (See Figure 9). Six on mount top, and six on
mount bottom. Points 1 through 6 control mount
extension and retraction tension. Points 1 and 6 control
mount right left swing tension, and points 3 and 4 control
display left right rotation tension.
NOTE:
It is important that correspnding points are
adjusted equally.
Example:
1 and 6, 2 and 5,
3 and 4, and their corresponding adjustment
points on mount bottom (See Figure 9).
To adjust mount tension:
1.
Determine which aspect of mount movement needs to
be adjusted and located appropriate adjustment
screws.
2.
Using the hex wrench provided, tighten or loosen
adjustment screws until desired tension is achieved
(See Figure 9).
Figure 9
CABLE MANAGEMENT
Cable management clips, for use with "zip-ties" or similar
devices, are provided for cable routing.
To use cable management clips:
1.
Zip tie cable to cable clip (B). (See Figure 10)
2.
Route cables down and under mount to display.
Figure 10
Decrease Tension
Increase Tension
2
3
4
5
6
1
Zip Tie
Cable
(B) x 1
