MSP-WM46UN2X2
Installation Instructions
6
Attach to Wall - Wood Studs
1.
Determine mounting location on wall.
2.
Determine mounting slots to be used for installation. (See
Note below and Figure 4)
NOTE:
If mounting to center of 24" studs, slots used must be
ce/- 4 1/2". For 16" studs, slots used must be
centered over three studs +/- 4 1/2". (See Figure 4)
Figure 4
3.
Using assembled mount as a template, mark four holes on
wall. Use a level to make sure of an even mount. (See
Figure 5)
4.
Drill four 1/4" holes 2 1/2" deep in wall at marked locations.
(See Figure 5)
5.
Install four 3/8 x 2 1/2" hex head lag screws (N) through
holes on mount and into four drilled holes on wall. (See
Figure 5)
Figure 5
Install Displays
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the MSP-WM46UN2X2 mount
does not exceed 280 lbs (127 kg). The weight of each
individual display cannot exceed 70 lbs (31.75 kg).
1.
Use four M6 x 25mm Phillips pan machine screws (J) to
attach four mounting buttons (H) to center holes on back of
display. (See Figure 6)
2.
Repeat Step 1 for each display to be installed.
Figure 6
24" studs
16" studs
center on 2 studs
+/- 4 1/2"
center on 3 studs
+/- 4 1/2"
3
4
x 4
5
(N) x 4
(H) x 4
(J) x 4
3
