Installation Instructions
MSP-WL4C
7
Array Installation
1.
Slide rotational spacer (V) into opening on array attachment
bracket. (See Figure 4)
2.
Use 5/16-18 x 3 1/8" button head cap screw (H), two thin
steel washers (T), plastic spacer (U), pocket washer (P),
pivot pin (L), rotational spacer (V) and 5/16-18 lock nut (Q)
to secure array (J) to MSP-WL4C arm (A). (See Figure 4)
NOTE:
Cable clip (M) can be used in place of pivot point spacer
(N) if additional cable management is desired. (See
Figure 4)
Figure 4
Display Installation
1.
Use 5/32" hex key (X) to remove two button head cap
screws and two nuts from each end of array bar. (See
Figure 3)
2.
Slide head assemblies off array bar. (See Figure 5)
Figure 5
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the MSP-WL4C mount up to (and
including) the display does not exceed 15 lbs (6.8 kg) per
display and 30 lbs (13.6 kg) total. Use with products heavier
than the maximum weight indicated may result in collapse of
the mount and its accessories causing possible injury.
3.
Carefully place display face down on protective surface.
4.
Place the Centris head (dual knob assembly) onto the back
of the display, aligning the mounting holes on the Centris
bracket with the mounting holes on the display.
CAUTION:
Using screws of improper size may
damage your display! Proper screws will easily and
completely thread into display mounting holes.
5.
Using Phillips screwdriver, install four M4x12mm button
head cap screws (B) through the mounting holes in Centris
bracket into the display (See Figure 6). Tighten all four
screws. Do not overtighten!
Figure 6
6.
Proceed to "ARRAY ASSEMBLY."
RECESSED MOUNTING HOLES
1.
Carefully place display face down on protective surface.
2.
Determine depth of recessed mounting holes relative to
back surface of display (against which Centris head dual
knob assembly will contact).
3.
Select proper length spacer and screw from table below:
NOTE:
All spacers used should be the same length. If the
recess depths result in multiple spacer lengths,
then select the longer spacer.
(V)
2
(H)
3
(U)
(T) x 2
(P)
(J)
(L)
(Q)
(A)
(N)
or
(M)
1
1
2
IF recess DEPTH is: THEN use spacer:
AND screw:
3/8" or less
F (3/8" long)
C (M4 x 20mm)
More than 3/8" up to
and including 3/4"
E (3/4" long)
D (M4 x 30mm)
(B) x 4
Centris
Bracket
5
