Installation Instructions
LW46/47/48/49/50/55UxP
11
9.
Tighten thumb nuts over threaded studs in four locations on
the hinged frame. (See Figure 9)
10. Replace and fasten four Phillips screws which were
removed in Step 1,
OR
replace the removed screws with
four 10-24 x 2-3/4" Phillips head screws (CD) to allow for a
larger depth adjustment of the outer frame. (See Figure 9)
11. Carefully lift (using two people) the swing door with attached
flat panel.
IMPORTANT ! :
Be sure to keep swing door at a 90°
angle to the wall to enable a smooth installation.
12. Keeping the swing door at a 90° angle against the wall, slide
the swing door so that hinge pins are above hinges.
13. Lower swing door to engage hinge pins into hinges. (See
Figure 10)
NOTE:
Some resistance is normal when the hinge pins drop
into the hinges.
Figure 10
14. Close swing door and add 10-24 x 3/8" button head security
screw (CA) in hole below latch to lock door. (See Figure 10)
Cabling
1.
Cables may be placed through the center slot in the wall
bracket flanges. (See Figure 11)
IMPORTANT ! :
Cables should not be placed OVER the
wall bracket flanges. Damage to cables may occur. (See
Figure 12)
Figure 11
Hinge pin
Hinge
13
12
14
(CA x 1)
Swing
door
Swing door must be closed before
Door
open
security screw (CA) is added
Be sure to keep swing door at a 90° angle to
the wall to enable a smooth installation.
Center
slot
1
Do
NOT
place
cables (dashed
Wall
flanges
Place cables through
center slot in wall
bracket flanges.
lines shown
above) in areas
over wall bracket
flanges as shown.
