Installation Instructions
LFAU
9
Cable Management
NOTE:
The following cable management options may vary
based on type of display being mounted and user
preference.
1.
Place FCA clip (N) into groove on back of Fusion mount with
clip handle in a vertical position. (See Figure 9)
2.
Rotate FCA clip (N) 90° in either direction until clip handle is
in a horizontal position. (See Figure 9)
3.
Repeat Steps 1-2 for all clips to be installed.
Figure 9
4.
Route cables along FCA clips to be used for cable
management. (See Figure 10)
5.
Use cable ties (P) to secure cables to FCA clips. (See
Figure 10)
Figure 10
6.
Route cables from display through front channel of column
assembly. (See Figure 11)
Figure 11
7.
Route cables down column channel, tucking them behind
height-adjustment carriage and underneath bracket holding
height-adjustment shaft. (See Figure 12)
8.
Snap back cover (G) onto back of column assembly making
sure cables fit through opening at bottom of cover. (See
Figure 12)
Figure 12
1
2
2
clip handle
(N)
4
5
(P)
cable (example)
front channel
6
(G)
cable opening
7
8
8
(rear view)
7
under bracket
