Installation Instructions
LCB2X1U / LCB2X1UP
11
Attaching Mount to CPA Extension Column
CAUTION:
WATCH FOR PINCH POINTS! Do not place
fingers between moveable parts.
1.
Check inside of mount housing for screws encroaching in
extension column area.
2.
Loosen two 5/16 x 3-1/2" button head cap screws on end of
housing until they no longer extend into the extension
column area inside housing, but do NOT remove the screws
completely. (See Figure 3)
Figure 3
3.
Slide ceiling mount (CC) up from below onto installed
column (not included). (See Figure 4)
4.
Tighten two button head screws loosened in Step 2. (See
Figure 3)
5.
Slide bottom stop collar (AA) onto installed column, lining up
holes in collar with holes in column.
6.
Install two 5/16" x 1" self-tapping screws (U) through two
5/16" flat washers (V), bottom stop collar (AA), and into
installed column. (See Figure 4)
7.
Install and tighten 5/16" x 3/4" set screw (W) into bottom
stop collar (AA). (See Figure 4)
8.
Loosen two button head screws tightened in Step 4, and
slide ceiling mount down extension column until it rests on
the bottom stop collar (AA). (See Figure 4)
9.
Rotate mount to desired position.
10. Re tighten two button head screws against column. (See
Figure 3)
Figure 4
Attaching Interface Brackets to Display
1.
Lower the latch mechanism on all interface brackets (DD).
(See Figure 5)
Figure 5
2
(CC)
x 2
(end
view)
8
4 10
3
(CC)
5
7
6
(U) x 2
(V x 2)
(AA)
(W) x 1
(DD)
1
Latch
mechanism
