KWY220
Installation Instructions
6
Figure 4
2
(K) X 2
(P) X 2
(A) X 2
(Q) X 2
(N) X 2
(T) X 2
1
3
4
(M) X 4
INSTALLATION
WARNING:
FAILURE TO PROVIDE ADEQUATE
STRUCTURAL STRENGTH FOR THIS COMPONENT CAN
RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE
TO EQUIPMENT! It is the installer’s responsibility to make
sure the structure to which this component is attached can
support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
Swing Arm Installation
1.
Insert pivot pin (Q) into Y-connector upper bore. (See Figure
4)
2.
Install spacer (N). (See Figure 4)
3.
Insert arm assembly (A) on pivot pin (Q). (See Figure 4)
4.
While holding nut (T) in lower bore of Y-connector, insert 5/
16-18 x 4" button head cap screw (K) through washers (M),
UHMW washer (N), arm assembly (A), spacer (P) and Y-
connector, into nut (T). (See Figure 4)
5.
Loosely install screw (K) using 3/16" hex key (F). (See
Figure 4)
6.
Repeat Steps 1 through 5 for second mount arm assembly
(A).
Display Installation
The mounting holes on the back of the display will be
flush with
the back surface, or
recessed into
the back. Refer to the
applicable installation procedure below.
Flush Mount Display Installation
CAUTION:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
CAUTION:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread
engagement in display may cause display to fall! Back out
screws ONLY as necessary to allow installation of Centris
bracket!
1.
Ensure Centris cup is able to swivel and tilt easily, yet still be
tight enough to hold display in desired position. Adjust as
required before proceeding. See "ADJUSTMENT" for
detail.
2.
Using Phillips screwdriver, carefully install two screws (R3)
into the
upper
mounting holes on the display. Thread
screws completely into display, then back out 3 complete
turns. (See Figure 5)
3.
Align two screws (R3) (installed on the back of the display in
the previous step) with the two top teardrop mounting holes
on the Centris cup. (See Figure 5)