Installation Instructions
KWY220
7
CAUTION:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Smaller area of
teardrop mounting holes must be facing downward for proper
installation. Reposition Centris cup if required.
Figure 5
4.
Using Phillips screwdriver, install two screws (R3) through
the
lower
mounting holes in Centris cup into the display.
(See Figure 6)
5.
Tighten all screws (R3). Do not overtighten! (See Figure 6)
Figure 6
6.
Repeat display installation procedures for second display.
7.
Proceed to "CABLE MANAGEMENT."
Recessed Mount Display Installation
1.
Ensure Centris bracket is able to swivel and tilt easily, yet
still be tight enough to hold display in desired position.
Adjust as required before proceeding. See
"ADJUSTMENT" for detail.
2.
Carefully place display face down on a clean and dry
surface.
3.
Determine depth of recessed mounting holes relative to
back surface of display.
4.
Select proper length spacer and screw from table below:
IMPORTANT ! :
All spacers used should be the same length.
If the recess depths result in multiple spacer lengths, then
select the longer spacer.
5.
Place the four spacers (R1 or R2) over each mounting hole
on the back of display. (See Figure 7)
6.
Orient mount so that mounting holes in the Centris cup are
aligned with the holes in the spacers (R1 or R2); rotate the
Centris cup as required (See Figure 7).
CAUTION:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
7.
Using Phillips screwdriver, install four screws (R4 or R5)
through the mounting holes in Centris cup, through the
spacers (R1 or R2), into display (See Figure 7).
8.
Tighten all four screws. Do not overtighten!
9.
Return to mount installation section to continue.
10. Repeat display installation procedure for second display.
Figure 7
(R3) x 2
Centris Cup
3
2
4
(R3) x 2
Centris Cup
IF recess DEPTH is: THEN use spacer:
AND screw:
3/8" or less
R1 (3/8" long)
R4 (M4 x 20mm)
More than 3/8" up to
and including 3/4"
R2 (3/4" long)
R5 (M4 x 30mm)
(R4 or R5)
(4 places)
(R1 or R2)
(4 places)
Centris Cup
7
5
