Installation Instructions
K4G210-310
9
Flush Mounting Holes
1.
Position faceplate in desired mounting position. Adjust as
required before proceeding. See Height Adjustment Section
for details.
2.
Using Phillips screwdriver, carefully install two M4 x 12mm
Phillips pan machine screws (P) into the
upper
mounting
holes on the display. Thread screws completely into display,
then back out 3 complete turns. (See Figure 13)
Figure 13
3.
Pick up and align display so that screws (P) (installed on the
back of the display in the previous step) fit into the mounting
holes on the faceplate. Lower the display firmly into place.
(See Figure 13)
4.
Using Phillips screwdriver, install two M4x12 mm
Phillips pan machine screws (P) through the
lower
mounting holes on faceplate into the display. (See
Figure 14)
Figure 14
5.
Tighten all four screws (P). Do not over-tighten!
NOTE:
If roll adjustment is desired for center faceplate, do not
tighten screws.
6.
Repeat Steps 1-5 for other displays.
7.
Proceed to Cable Management Section.
Recessed Mounting Holes
NOTE:
If faceplate does not fit into recessed area of display,
proceed with the steps in this section.
1.
Determine depth of recessed mounting holes relative to
back surface of display (against which faceplate will
contact).
2.
Select proper length spacer and screw from table below:
NOTE:
All spacers used should be the same length. If the
recess depths result in multiple spacer lengths, then
select the longer spacer.
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily and completely thread
into display mounting holes.
3.
Using Phillips screwdriver, carefully install two selected
screws (N or M) through selected spacers (Q or R) into the
upper
mounting holes on the display. Thread screws
completely into display, then back out 3 complete turns.
(See Figure 15)
4.
Pick up and align display so that screws (N or M) (installed
on the back of the display in the previous step) fit into the
mounting holes on the faceplate. Lower the display firmly
into place. (See Figure 15)
Figure 15
faceplate
(array arm not shown for clarity)
(P) x 2
2
faceplate
(array arm not shown for clarity)
(P) x 2
4
IF recess DEPTH is: THEN use spacer:
AND screw:
3/8” or less
Q (3/8” long)
N (M4 x 20mm)
More than 3/8” up to
and including 3/4”
R (3/4” long)
M (M4 x 30mm)
(Q or R) x 2
(N or M) x 2
3
faceplate
(array arm not shown for clarity)
4
