Installation Instructions
K2P Series
7
Assembly And Installation
Connecting to Pole
1.
Determine approximate location for mount keeping in mind
display size, extension, height adjustment requirements.
2.
Place mount (A) against pole with clamp (E) on opposite
side of pole. (See Figure 1)
Figure 1
3.
Using 5/32” hex key (K) and appropriate length screws,
loosely attach assembly to pole clamp (E). If installing to 1
1/2” NPT pipe, use 1/4-20 x 1 1/2” button head cap screws
(F). If installing to 1 1/2” diameter pipe, use 1/4-20 x 1"
button head cap screws (G). (See Figure 1)
4.
Position mount at desired height and orientation.
5.
Equally tighten screws against mount and the pole clamp.
Array Installation (K2C22H and K2C22HSXF1
Models ONLY)
1.
Slide rotational spacer (J10) into opening on array
attachment bracket. (See Figure 2)
2.
Use 5/16-18 x 3" button head cap screw (J3), two thin steel
washers (J8), plastic spacer (J9), pocket washer (J5), pivot
pin (J4), pivot point spacer (J12) and 5/16-18 lock nut (J6)
to secure array (J1) to K2 arm (A). (See Figure 2)
NOTE:
Cable clip (J11) can be used in place of pivot point
spacer (J12) if additional cable management is desired.
(See Figure 2)
Figure 2
Display Installation
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the K2P Series Monitor Arm
up to (and including) the display does not exceed the weight
limit listed below. Use with products heavier than the
maximum weight indicated may result in collapse of the
mount and its accessories causing possible injury.
3
(F or G) x 4
(E)
(A)
MODEL
Max Weight
Allowed for EACH
Display
Max Weight
Capacity of
Mounting System
K2P110
25 lbs
(11.34 kg)
25 lbs
(11.34 kg)
K2P120
25 lbs
(11.34 kg)
25 lbs
(11.34 kg)
K2P220
25 lbs
(11.34 kg)
50 lbs
(22.68 kg)
K2P22H
9 lbs
(4.08 kg)
18 lbs
(8.16 kg)
(J10)
1
(J3)
2
(J9)
(J8) x 2
(J5)
(J1)
(J4)
(J6)
(A)
or
(J12)
(J11)
