JHS210/ JHSV
Installation Instructions
6
Attach Interface Bracket to Display
1.
Lay display face down on a clean and dry flat surface.
2.
Attach Interface Bracket (S) to display using appropriate
screws (D, E, F, G, H, L, M, N). (See Figure 3)
NOTE:
If the display has a recessed mounting surface,
spacers (K or O) between the display and Interface
Bracket (S) may be required.
3.
Tighten all screws.
Figure 7
Attach Display to Mount
1.
Start two Phillips pan head screws (C) into top mounting
holes on interface bracket (S). (See Figure 8)
2.
Align two screws in interface bracket (S) with upper
mounting holes in Centris cup and lower display until
screws are seated in lower area of teardrop mounting holes.
(See Figure 8)
Figure 8
3.
Hold display so that display back is against Centris cup and
install two Phillips pan head machine screws (C) through
lower mounting holes in Centris cup and into lower
mounting holes in interface bracket (S). (See Figure 9)
Figure 9
4.
Route cables and wires to display.
ADJUSTMENTS
To adjust display Roll, Pitch, and YAW tension:
1.
Disconnect all wires and cable from the display.
2.
Remove two
Lower
screws securing display to Centris cup.
3.
Loosen two
Upper
screws securing display.
4.
Lift display upward and away from mount.
5.
Using a Phillips screwdriver turn the tension adjustment
screw clockwise to increase tension, or counter-clockwise
to decrease tension. (See Figure 10)
6.
Re-install display.
Figure 10
2
(S) x 1
(D, E, F, G, H, L, M, N)
3
(C) x 4
2
(S) x 1
3
(S) x 1
(C) x 4
