Installation Instructions
JSBV
5
INSTALLATION
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! DO NOT substitute
hardware. Only use hardware provided or specified by
manufacturer.
1.
Place JSBV interface bracket over the mounting holes on
the back of the display, making sure to center the bracket as
much as possible.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DAMAGE TO EQUIPMENT OR TO MOUNT FALLING
CAUSING SERIOUS PERSONAL INJURY ! Use proper size
and length hardware depending on display.
NOTE:
Use spacers from hardware bag C if the display
mounting holes are recessed, or if there is some
protrusion or bowing in the back of display.
NOTE:
Use screws from hardware bags A, B, or E, dependent
upon whether or not spacers are required.
2.
Using the same number of spacers (if required) and screws
as holes in the display back, attach JSBV interface bracket
to the display back. (See Figure 1)
Figure 1
CAUTION:
PREVENT EQUIPMENT DAMAMGE! Tighten
each screw carefully, but do NOT overtighten.
Attach Interface Bracket to Display
1.
Lay display face down on a clean and dry flat surface.
2.
Attach Interface Bracket (A) to display using appropriate
screws (C-H, N-Q). (See Figure 2)
NOTE:
If the display has a recessed mounting surface,
spacers (K or J) between the display and Interface
Bracket (A) may be required.
3.
Tighten all screws.
Figure 2
Attach Display to Mount
1.
Start two M4 x 8mm Phillips pan head screws (B) into top
mounting holes on interface bracket (A). (See Figure 3)
2.
Align two screws in interface bracket (A) with upper
mounting holes in Centris cup and lower display until
screws are seated in lower area of teardrop mounting
holes. (See Figure 3)
Figure 3
3.
Hold display so that display back is against Centris cup and
install two M4 x 8mm Phillips pan head machine screws (B)
(J) or (K) if needed
[from hardware bag C]
(A)
(D through H,
N through Q)
2
2
(A)
(C-H, N-Q)
(B) x 4
2
(A)
