Instruction Manual
GPM-110
4
Installation Instructions
NOTE:
Read the “Important Warnings and Precautions” on
Page 2.
Installing the Wall Bracket (Step 1)
The wall bracket can be mounted vertically or horizontally.
Mounting the bracket vertically allows you to tilt the display up
and down. Mounting the bracket horizontally allows you to pivot
the display side-to-side.
To install the wall bracket, perform Option A or Option B as
applicable.
OPTION A (Drywall Installation Procedures)
A.
Determine the exact mounting location prior to
installation, considering screen size as well as the mount
tilt radius.
B.
Position the wall bracket (20) in the vertical position or
the horizontal position, as needed.
C.
Using the wall bracket (20) as a template at the desired
mounting location, mark the location of the four outer
mounting holes.
NOTE:
This procedure applies to a minimum drywall
thickness of ½” inch (12.7 mm).
D.
Using a 3/8-inch drill, drill four pilot holes at the locations
marked in Step 1.A.
E.
Install an anchor (30) in one of the pilot holes and tighten
anchor bolt until it is fully seated (see Figure 1).
F.
Remove and retain bolt from anchor (30) and repeat
Step 1.E and 1.F for three remaining anchors (30).
G.
Using four bolts, with washers installed, secure wall
bracket (20) to wall.
OPTION B (Wall Stud Installation Procedures)
A.
Determine the exact mounting location prior to
installation, considering screen size as well as the mount
swing and extension radius.
B.
Position the wall bracket (20) in the vertical position or
the horizontal position, as needed.
C.
Locate stud and, using wall bracket (20) as a template at
the desired height, mark the location of the two center
mounting holes.
D.
Using the two wood screws (40), secure wall bracket
(20) to wall.
Step 1
Installing Wall Bracket – Vertically
Installing Wall Bracket – Horizontally
A
%%c
0.375 (PREDRILL HOLE)
INSERT ANCHOR INTOPPREDRILLED HOLE
CW
ANCHOR BARBP(STOPS ANCHOR ROTATION)
#10-24
Screw
0.375 (Predrill Hole)
Insert anchor into
predrilled hole
Anchor Barb
(Stops anchor rotation)
Anchor (30)
Turn 10-24 screw clockwise
until anchor fully seats
against back side of wall
CW
Figure 1. Anchor Installation
A
B
A
(Corner Holes)
B
(Center Holes)
