Installation Instructions
FWDSK110
5
Mount Installation
After determining the site meets the installation requirements:
1.
Identify desired mounting location on wall.
2. Using a stud finder or similar method locate studs.
3. Align mounting holes in mount with studs making sure
mounting holes are centered on studs. (See Figure 2)
4. Mark location of three mounting holes on wall.
5. Drill three 1/2" (Ø13mm) holes. (See Figure 2)
Figure 2
6. Hold metal channel on anchor (L) flat alongside
plastic straps and slide channel through hole.
(See Figure 3)
Figure 3
7. Holding plastic straps on anchor (L), pull anchor away
from wall until channel rests flush behind wall making
sure anchor channel is positioned vertically on stud as
show in figues below. (See Figure 4)
8. Slide plastic cap on anchor (L) towards wall until
flange of cap is flush with wall. (See Figure 4)
Figure 4
9. Snap off plastic straps on anchor at wall by pushing
side to side, snapping off straps level with flange of
plastic cap. (See Figure 5)
10. Repeat steps 6 through 9 for each mounting hole.
1/2" (Ø13mm) x3
Mounting holes
centered on
studs
5
(A) x1
(L) x3
Drywall
Plastic Straps
Plastic Cap
Steel Stud
Drywall
Anchor Metal Channel
SIDE VIEW
(M) x3
