KXC Series
Installation Instructions
12
Pivot Adjustment Range
1.
Adjust arm angles as desired within a 90 degree range from
the pivot point of the arm and a perpendicular centerline of
mount. (See Figure 21)
WARNING:
Swinging the arm beyond this range may result
in the mount slipping off the desk causing serious injury!
Figure 21
Cable Management
1.
Press insides of cable management covers at both ends to
unhinge tabs on either end of cable management cover on
upper arm. (See Figure 22)
2.
Lift cable management cover up until tabs are unhinged and
cover is in the “open” position. (See Figure 22)
Figure 22
Figure 23
3.
Route cables through cable management channel on upper
arm. (See Figure 23)
IMPORTANT ! :
Be sure to leave enough slack in the
cables near display and arm joint to allow for full arm
articulation!
4.
Close cable management covers on monitor arm. (See
Figure 23)
5.
Route cables through cable clips on lower arm(s). (See
Figure 23)
perpendicular centerline
90 degrees range
of motion per arm
pivot point of the arm
(top view)
cable management cover tabs
1
2
5
4
3
3
cable (typical)
2
5