Installation Instructions
KXC Series
11
Rotational Adjustment
NOTE:
(Optional) Rotational adjustment may be locked by
installing rotational locking screw (Q) into back of
faceplate. (See Figure 17)
Figure 17
5.
The monitor may be adjusted 90 degrees in either direction
in order to provide a portrait view of the monitor. (See Figure
16)
6.
Use 3/16” hex key (K) to adjust rotational adjustment screw
to adjust rotational tension. (See Figure 16)
Lift Arm Tension Adjustment
1.
Tension may be adjusted with tension adjustment screw
inside cable management cover and 1/8” hex key (L). Turn
clockwise to reduce tension or counter-clockwise to
increase tension. (See Figure 18)
Figure 18
Display Removal
WARNING:
Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 19)
1.
Make sure display is in the upright position.
2.
Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 19)
Figure 19
Display Removal Security Screw
NOTE:
In order to prevent display from being easily removed
from mount using the quick release lever, install
M4x4mm security screw (R) into lower hole on back of
faceplate. (See Figure 20)
Figure 20
(Q)
Reduce tension
Increase tension
(lighter display)
(heavier display)
Do NOT over-tension
adjustment tension
screw.
quick release tab
2
(R)
