FCASCA
Installation Instructions
6
Assembly And Installation
1.
Cut column straps (E) to length based on size of structural
column. See table below for details.
NOTE:
If structural column is not one of these exact diameters,
it will be necessary to temporarily install strap around
column to determine where it should be cut.
2.
Use two 5/16-18 x 7/8" button head cap screws (CA) and
two 5/16-18 hex nuts (CC) to attach column strap (E) to
column clamp (D). (See Figure 1)
Figure 1
3.
Wrap strap around column at desired mounting height. (See
Figure 2)
4.
Use 5/16-18 x 3" hex head carriage screw (CD) and
.750x.350x.060 spacers (CB) to secure strap around
column. Tighten to a torque rating of 75 inch pounds. (See
Figure 2)
Figure 2
Thinstall Mounts (TS118/218/318) and FMSWM
NOTE:
If installing to MTMS1U or MTMP1U, proceed to
MTMS1U/MTMP1U section.
5.
Loosely install appropriate hardware (AA and AB) or (BA
and BB) to appropriate mounting hole in top column clamp
(D). (See Figure 3) or (See Figure 4)
6.
Hang mount onto loosely installed screw and tighten screw.
7.
Install lower column clamp (D) following Steps 1-4, aligning
it with the lower mounting hole on mount. (See Figure 3) or
(See Figure 4)
8.
Use appropriate hardware (AA and AB) or (BA and BB) to
secure mount to lower column clamp (D). (See Figure 3) or
(See Figure 4)
Diameter
Strap Length
12"
32"
18"
47.5"
24"
65"
2
(CA) x 2
2
(CC) x 2
(E)
(D)
3
4
(CD)
(CB)
Figure 3
TS118
TS218
TS318
(BA)
(BA)
(BB)
5
6
7
8
(
(BB)
(BA)
(BA)
(BB)
6
8
(BB)
5
7
(AA)
(AA)
(AB)
6
8
(AB)
5
7
