R
CHIEF EZ LINER S21M
USERS MANUAL
Pump Removal
1. Disconnect power supply cord from power supply
and pull cord out through top of pedestal opening.
2. Coil remote control switch cord and position it on
top of motor.
or
Disconnect remote control switch cord from motor
and pull it out through bottom of pedestal.
3. Lift pump out of pedestal.
NOTE: If bolts securing pump to base of pedestal
have not previously been removed, remove
them. The bolts are only necessary for
transporting the EZ Liner.
Pump Installation
1. Set pump into pedestal.
NOTE: It may be necessary to pull up slightly on
hose that attaches pump to hose block to
prevent it from being pinched under pump.
2. If remote control switch cord is coiled and posi-
tioned on top of motor, route hand-held control unit
out through bottom of pedestal.
If remote control switch cord is disconnected,
reroute cord at top of pedestal through to bottom of
pedestal and reconnect it to motor.
3. Insert power supply cord at top of pedestal, route it
through to bottom of pedestal, and plug it into
power supply.
IMPORTANT: Following installation, check posi-
tion of all hydraulic and electrical
lines to be sure they are not pinch-
ed under pump.
11
HYDRAULIC PUMP REMOVAL/INSTALLATION
