Installation Instructions
CPA265
3
PARTS FOR INSTALLATION
A (1)
[CPA265]
B (2)
M6x16mm
C (2)
M6x16mm
F (1)
M6
(security)
D (2)
M6
E (2)
M6
INSTALLATION
Installing to a CPA Pipe
1.
Making sure holes are aligned on CPA265 (A) and CPA
column (not included), lift CPA265 (A) into bottom opening
of CPA column. (See Figure 1)
2.
Install either one M6x16 button head screw (B) or security
screw (C) through M6 lock washer (D) and M6 flat washer
(E) into hole on side of CPA pipe where the adapter plate on
CPA265 is located. (See Figure 1)
3.
On the opposite side of CPA pipe, use the other M6x16
button head screw (B) or security screw (C), an M6 lock
washer (D) and an M6 flat washer (E) to secure CPA265 to
CPA column. (See Figure 1)
Figure 1
4.
Use “L”-shaped M6 hex key (F) to tighten bottom bolt. (See
Figure 1)
Install to Projector Mount
IMPORTANT ! :
The CPA265 adapter is compatible with
projector mounts with a 1 1/2" NPT threaded opening.
1.
Thread projector mount (not included) onto the CPA265 (A)
until hand tight.
2.
Turn projector mount clockwise or counter-clockwise until
front of mount is facing target.
3.
Secure projector mount to pipe by turning set screw with a
5/32” hex key until tight.
CAUTION:
DO NOT OVERTIGHTEN! Over-tightening of
set screw can damage threads on pipe.
Figure 2
4.
Turn security screw (access from bottom of projector mount)
(See Figure 3) using a Phillips screwdriver until set screw
cannot be seen through set screw access hole in projector
mount. (See Figure 3)
Figure 3
2
1
CPA pipe
(not included)
(B) or (C)
3
(B) or (C)
hole on side
of adapter plate
(D) x 2
(E) x 2
(A)
underneath view
4
1
3
Set screw
access hole
x 1
(example)
(A)
projector mount
(bottom view)
4
x 1
Security screw
