![background image](http://html.mh-extra.com/html/chief/chf1001/chf1001_owners-manual_2601204012.webp)
7
revised 04/15
chIef
®
fume extractor
recommended to fine tune the desired movement.
to adjust the hood joint swivel assembly, follow the
same steps as above but first retract the flexible duct to
gain access to the hood joint assembly.
7.3 SPARK ARRESTOR
• Removing the spark arrestor may expose you
to hazardous contaminants. take all necessary
precautions including protective clothing such as
eye protection and gloves.
• Follow all local safety and environmental codes in
disposal of the accumulated particulate.
an impingement spark arrestor is located at the inlet
of the fume extractor immediately below the base of
the extraction arm. during operation, spark embers
or large particulate may accumulate on these baffles.
the baffles should be inspected and accumulated
material should be removed on a regular basis.
to inspect the baffles, unhook the two draw latches
located on the left and right side of the box just below
the inlet and pull the spark arrestor assembly towards
the discharge side of the fume extractor. clean the
surfaces and dispose of any collected material.
replace the spark arrestor assembly back into the
unit and engage each draw latch. ensure that the
assembly is flush against the gasket material and
compressed when latches are closed.
!
CAUTION
FIGURE 5
Spark Arrestor Maintenance
61-10083